Zen Raku Kiln

The Zen Raku Kiln is constructed of vacuum formed fiber insulation that is rigid and durable without any seams. Not to be confused with the more commonly known felt blanket that is more fragile, this vacuum-formed insulation is custom built for Zen Pottery Equipment. The kiln has amazing insulating properties and yet it is very lightweight.

The exterior of the kiln is constructed of steel. The inside dimensions are 16” x 24”. It has a top exhaust port and a side view port. The burner is a venturi, accompanied by a brass needle valve, automatic safety shutoff equipment, and burner stand for stability.

FIRING
Firing times for raku are very fast. First fi ring takes 15-40 minutes. This is the longest time because the initial time to heat up the brick stand, shelf, posts, etc. consecutive fi rings take 10-20 minutes. In classroom sessions the time factor is a problem--with this raku kiln many pieces can be fi red in a short period.

GAS SAVINGS encountered are obvious. A 100lb. bottle of propane supplies many hours of fi ring (approximately 50 loads of pots). With energy prices at a premium this feature is so important.

PORTABILITY
The kiln body that includes the fi ber liner and expanded metal shell weighs only 27 pounds. It can be taken most anywhere. Set-up takes minutes and then you’re ready to fire.

ZEN RAKU KILN
Includes kiln body, burner/stand, valve, automatic safety shut-off valve, thermocouple and pilot, hose, gauge, regulator/POL, instruction manual

ZEN RAKU KILN INDIVIDUAL RAKU PARTS 
Venturi Burner/Stand
Pilot Safety Shut-off valve
Regulator and POL
Brass Needle Valve
Pressure Gauge
L.P. Hose (10 ft.)
Thermocouple
Copper Pilot Tube
Instruction Manual
KILN BODY:
Expanded Metal Shell
Vacuum-formed Fiber Liner
Metal Clips: Anchors for Spy Hole and Exhaust Port
Spy Hole
Exhaust Port
BURNER:
Complete with Gas Safety  Shut-off Equipment (excludes Hose, Regulator and Gauge)